And if you are using a laser rangefinder – that shouldn’t be much of an issue anyway.Īlways remember to practice with your setup first before going into the field.If you have a shorter draw length, and/or you shoot less draw weight, choosing a lightweight arrow shaft to gain speed is actually counterproductive when it comes to penetration. Increased FOC, better long-range accuracy, and better penetration outweigh drop by far. So, to answer the question, “What Grain Broadhead Should I use for Deer?” I would say that if your setup allows you to, you should shoot 125-grains over 100-grains. As the arrow takes more energy from the bow, less noise and vibration will be produced. The heavier the arrow, the more energy it can absorb from the bow and convert into kinetic energy. The two main variables are arrow weight and arrow speed! If kinetic energy is your goal, heavier arrows are better than faster ones.

Make sure to check your local hunting regulations regarding minimum draw weight and broadheads. But a well-placed short-range shot should be efficient nevertheless. lbs probably won’t lead to a pass-through on a deer. To effectively hunt deer, you aim for a minimum of a KE of 25-41 ft. If your bow setup ultimately shoots a 400 grain arrow at a respectable 250 fps (a typical field-output for a modern rig), your actual kinetic energy or “power” will be: Kinetic energy of an arrow can be found by using the formula KE=(mv²)/450,240 where m = mass of the arrow in grains and v = velocity of the arrow in fps. “The measurable “power” of your bow – it’s total kinetic energy output – ultimately depends upon just two variables: the mass of the arrow and the speed of the arrow. The heavier your arrow, the greater its potential penetration. An excellent article at talks about Kinetic Energy and how the speed and mass of the arrow influence its ability to penetrate a target. Heavier arrows (no matter the type of broadhead) will produce more KE and better momentum. Nowadays, most bowhunters use laser rangefinders, a flatter trajectory, and guessing the distance is not that much of an issue anymore. So if your bow has enough poundage, you might as well go for it. Maybe you are wondering what 25 grain more upfront will do? Are heavier heads better?ġ25-grain broadheads could (depending on your spine) increase F.O.C., long-range accuracy, and penetration. See where this goes? To stay within the IBO standards of the 350-grains total, a sufficient arrow for 70 lbs draw weight, and 30″ draw length, broadheads had to get lighter! Heavier broadheads would break the 350-grain limit… 125-Grain Broadhead – The Benefits?Īs mentioned above, the majority of deer hunters use 100-grain broadheads. Jeff Johnston says that “ It wasn’t until sometime in the early 90s when the speed war between manufacturers began boiling over that 100-grainers even became popular.” he further goes on that due to the differences in IBO and AMO speed measuring, broadheads got lighter! Everybody got obsessed with arrow speed. There is an excellent article over at Petersen’s Hunting that, in my opinion, explains very well why nowadays almost all broadhead manufacturers promote 100-grain heads. Most manufacturers offer 100-grain heads, and in combination with a carbon arrow, this gives you a decent weight broadhead for deer (and most other game). The weight of an arrow also directly affects the arrow speed, which is generally measured in FPS. Picking a good broadhead weight depends on your arrow weight, bow poundage, field tip grain, and your “normal” shooting distance. The more weight that is located in the front half of the arrow, the more forward is the arrow’s center-of-balance.” stands for “front-of-center.” FOC describes the percentage of the arrow’s total weight that is located in the front half of the arrow.

Bear lights out arrow grains